Interface Configuration; Figure 180: Lldp Interface Configuration; Table 161: Lldp Interface Configuration Fields - D-Link DWS-4026 User Manual

Software User Manual
12/10/09
I C
NTERFACE ONFIGURATION
Use the LLDP Interface Configuration page to specify LLDP parameters that are applied to a specific interface.
To display the LLDP Interface Configuration page, click LAN > L2 Features > LLDP > Interface Configuration in the
navigation tree.
Field
Interface
Transmit
Receive
Notify
Transmit Management
Information
Optional TLV(s)
• If you make any changes to the page, click Submit to apply the new settings to the system.
Document 34CSFP6XXUWS-SWUM100-D7

Figure 180: LLDP Interface Configuration

Table 161: LLDP Interface Configuration Fields

Description
Specifies the port to be affected by these parameters.
Enables or disables the transmission of LLDP protocol data units (PDUs). The default
is disabled.
Enables or disables the ability of the port to receive LLDP PDUs. The default is
disabled.
When notifications are enabled, LLDP interacts with the Trap Manager to notify
subscribers of remote data change statistics. The default is disabled.
Select the check box to enable the transmission of management address instance.
Clear the check box to disable management information transmission. The default is
disabled.
Select each check box next to the type-length value (TLV) information to transmit.
Choices include:
• System Name. To include system name TLV in LLDP frames. To configure the
System Name, see "After a successful login, the System Description page displays.
Use this page to configure and view general device information." on page
• System Description. To include system description TLV in LLDP frames.
• System Capabilities. To include system capability TLV in LLDP frames.
• Port Description. To include port description TLV in LLDP frames. To configure the
Port Description, see "Port Description" on page
D-Link Unified Access System
115.
Managing LLDP
58.
Page 265