Sntp Global Configuration; Figure 95: Sntp Global Configuration; Table 80: Sntp Global Configuration Fields - D-Link DWS-4026 User Manual

Software User Manual
12/10/09
MD5 (Message Digest 5) Authentication safeguards device synchronization paths to SNTP servers. MD5 is an algorithm that
produces a 128-bit hash. MD5 is a variation of MD4, and increases MD4 security. MD5 verifies the integrity of the
communication, authenticates the origin of the communication.
The SNTP folder contains links to view or configure the following features:
•

"SNTP Global Configuration"

• "SNTP Global Status"
• "SNTP Server Configuration"
• "Configuring and Viewing ISDP Information"
SNTP G C
LOBAL ONFIGURATION
Use the SNTP Global Configuration page to view and adjust SNTP parameters.
To display the SNTP Global Configuration page, click LAN > Administration > SNTP > SNTP Settings in the navigation
menu.
Field
Client Mode
Port
Unicast Poll Interval
Document 34CSFP6XXUWS-SWUM100-D7

Figure 95: SNTP Global Configuration

Table 80: SNTP Global Configuration Fields

Description
Use drop-down list specify the SNTP client mode, which is one of the following modes:
• Disable: SNTP is not operational. No SNTP requests are sent from the client nor are
any received SNTP messages processed.
• Unicast: SNTP operates in a point to point fashion. A unicast client sends a request
to a designated server at its unicast address and expects a reply from which it can
determine the time and, optionally the round-trip delay and local clock offset relative
to the server.
• Broadcast: SNTP operates in the same manner as multicast mode but uses a local
broadcast address instead of a multicast address. The broadcast address has a
single subnet scope while a multicast address has Internet wide scope.
Specifies the local UDP port to listen for responses/broadcasts. Allowed range is (1 to
65535). Default value is 123.
Specifies the number of seconds between unicast poll requests expressed as a power
of two when configured in unicast mode. Allowed range is (6 to 10). Default value is 6.
D-Link Unified Access System
Configuring SNTP Settings Page 167