Initiating Manual Power Adjustments; Access Point Software Download; Figure 307: Manual Power Adjustments - D-Link DWS-4026 User Manual

D-Link Unified Access System
• The AP has been rebooted since the channel plan was computed and acquires a static channel that has been set
statically via local database.
• The channel has been set manually through the advanced page.
• The auto-channel mode has been disabled in the profile for this AP.

Initiating Manual Power Adjustments

If you select Manual as the Power Adjustment Mode on the Configuration tab, you can manually initiate the power adjustment
algorithm on the Manual Power Adjustments page.
The Current Status of the plan shows one of the following states:
• None: The power adjustment algorithm has not been manually run since the last switch reboot.
• Algorithm In Progress: The power adjustment algorithm is running.
• Algorithm Complete: The power adjustment algorithm has finished running.
A table displays to indicate proposed power adjustments. Each entry shows the AP along with the current and new power
levels. To accept the proposed change, click Apply. You must manually apply the power adjustment for the proposed
assignments to be applied.
• Apply In Progress: The switch is adjusting the power levels that the APs use.
• Apply Complete: The algorithm and power adjustment are complete.
A P S
CCESS OINT OFTWARE
The Unified Switch can upgrade software on the APs that it manages. The Cluster Controller can update code on APs
managed by peer wireless switches.
To upgrade one or more AP from the switch that manages it, click the WLAN > Administration > AP Management >
Software Downloads tab.
Page 446 AP Management

Figure 307: Manual Power Adjustments

D
OWNLOAD
Software User Manual
Document 34CSFP6XXUWS-SWUM100-D7
12/10/09