Rip Route Redistribution Summary; Figure 205: Rip Route Redistribution Summary; Table 186: Rip Route Redistribution Summary Fields - D-Link DWS-4026 User Manual

D-Link Unified Access System
Field
Metric
Distribute List
You configure ACLs through the pages under LAN > Access Control Lists > IP Access Control Lists. When used for route
filtering, the only fields in an access list that get used are:
• Source IP Address and netmask
• Destination IP Address and netmask
• Action (Permit or Deny)
All other fields (source and destination port, precedence, tos, etc.) are ignored.
The source IP address is compared to the destination IP address of the route. The source IP netmask in the access list rule
is treated as a wildcard mask, indicating which bits in the source IP address must match the destination address of the route.
(Note that a 1 in the mask indicates a Don't Care in the corresponding address bit.)
When an access list rule includes a destination IP address and netmask (an extended access list), the destination IP address
is compared to the network mask of the destination of the route. The destination netmask in the access list serves as a
wildcard mask, indicating which bits in the route's destination mask are significant for the filtering operation.
• If you make changes to the page, click Submit to apply the changes to the system.
• To delete a configured route, click Delete.
RIP R R
OUTE EDISTRIBUTION
Use the RIP Route Redistribution Summary page to display Route Redistribution configurations.
To display the page, click LAN > Monitoring > L3 Status > RIP > Route Redistribution Summary in the navigation menu.
Field
Source
Page 298 Configuring RIP
Table 185: RIP Route Redistribution Configuration Fields (Cont.)
Description
Sets the metric value to be used as the metric of redistributed routes. This field
displays the metric if the source was pre-configured and can be modified. The valid
values are 1 to 15.
Enter the ACL ID for an access list that filters the routes to be redistributed by the
destination protocol. Only permitted routes are redistributed.
S
UMMARY

Figure 205: RIP Route Redistribution Summary

Table 186: RIP Route Redistribution Summary Fields

Description
The protocol used to obtain the route.
Software User Manual
Document 34CSFP6XXUWS-SWUM100-D7
12/10/09