D-Link Unified Access System
8 Configure the third VAP.
Because this VAP uses WPA Enterprise, wireless clients must authenticate by using an external
RADIUS server. Make sure that the RADIUS Authentication Server Configured field shows the status
as Configured. For more information about configuring the RADIUS server, see the steps that pertain
to setting up the RADIUS server in
a. Delete the existing SSID and enter Voice in the SSID field.
b. In the VLAN field, enter 30.
c. From the Security option, select WPA.
Additional security fields appear.
d. Clear the WPA option so that only WPA2 clients can connect to the VAP.
e. Select WPA Enterprise
f. Select the CCMP (AES) option.
g. From the L2 Distributed Tunneling Mode field, select Enable to allow the clients to roam among APs in different
subnets without losing their network connection.
i.
From the DiffServ Policy UP field, select the policy to apply to traffic transmitted from wireless clients to the AP.
j.
Click Submit.
Page 552
Configuring a Virtual Access Point
"Configuring 802.1X Network Access Control" on page
Software User Manual
Document 34CSFP6XXUWS-SWUM100-D7
12/10/09
548.