Software User Manual
12/10/09
C
RIP
ONFIGURING
RIP is an Interior Gateway Protocol (IGP) based on the Bellman-Ford algorithm and targeted at smaller networks (network
diameter no greater than 15 hops). The routing information is propagated in RIP update packets that are sent out both
periodically and in the event of a network topology change. On receipt of a RIP update, depending on whether the specified
route exists or does not exist in the route table, the router may modify, delete, or add the route to its route table.
The L3 Features > RIP menu page contains links to the following web pages that configure and display RIP parameters and
data:
•
"RIP Configuration"
•
"RIP Interface Summary"
•
"RIP Interface Configuration"
•
"RIP Interface Summary"
•
"RIP Route Redistribution Summary"
RIP C
ONFIGURATION
Use the RIP Configuration page to enable and configure or disable RIP in Global mode.
To display the page, click LAN > L3 Features > RIP > Configuration in the navigation tree.
Field
RIP Admin Mode
Document
34CSFP6XXUWS-SWUM100-D7
Figure 200: RIP Configuration
Table 182: RIP Configuration Fields
Description
Select Enable or Disable from the dropdown menu. If you select Enable, RIP is
enabled for the switch. The default is Disable.
D-Link Unified Access System
Configuring RIP
Page 293