D-Link DWS-4026 User Manual page 110

D-Link Unified Access System
Field
Port Type
STP Mode
Admin Mode
Broadcast Storm Recovery
Mode
Broadcast Storm Recovery
Level
Multicast Storm Recovery
Mode
Multicast Storm Recovery
Level
Unicast Storm Recovery Mode
Unicast Storm Recovery Level
LACP Mode
Page 110 Configuring and Viewing Device Port Information
Table 43: Port Configuration Fields (Cont.)
Description
For most ports this field is blank. Otherwise the possible values are:
• Mirrored: Indicates that the port has been configured as a monitoring port and is the
source port in a port mirroring session. For more information about port monitoring
and probe ports, see "Multiple Port Mirroring" on page
• Probe: Indicates that the port has been configured as a monitoring port and is the
destination port in a port mirroring session. For more information about port
monitoring and probe ports, see
• Port Channel: Indicates that the port has been configured as a member of a port-
channel, which is also known as a link Aggregation Group (LAG). For information
about configuring port channels, see
page 238.
Shows the Spanning Tree Protocol (STP) Administrative Mode for the port or LAG. For
more information about STP, see
The possible values for this field are:
• Enable: Enables the Spanning Tree Protocol for this port.
• Disable: Disables the Spanning Tree Protocol for this port.
Use the pulldown menu to select the port control administration state, which can be
one of the following:
• Enable: The port can participate in the network (default).
• Disable: The port is administratively down and does not participate in the network.
Enable or disable this option by selecting one of the following options on the pulldown
entry field:
• Enable: When the broadcast traffic on the specified Ethernet port exceeds the
configured threshold, the switch blocks (discards) the broadcast traffic.
• Disable: The port does not block broadcast traffic if traffic on the port exceeds the
configured threshold. The factory default is disabled.
Specify the data rate at which storm control activates. The value is a percentage of port
speed and ranges from 0-100. The factory default is 5 percent of port speed.
Enable or disable this option by selecting one of the following options on the pulldown
entry field:
• Enable: When the multicast traffic on the specified Ethernet port exceeds the
configured threshold, the switch blocks (discards) the multicast traffic.
• Disable: The port does not block multicast traffic if traffic on the port exceeds the
configured threshold. The factory default is disabled.
Specify the data rate at which storm control activates. The value is a percentage of port
speed and ranges from 0-100. The factory default is 5 percent of port speed.
Enable or disable this option by selecting one of the following options on the pulldown
entry field:
• Enable: When the unicast traffic on the specified Ethernet port exceeds the
configured threshold, the switch blocks (discards) the unicast traffic.
• Disable: The port does not block unicast traffic if the unicast traffic on the port
exceeds the configured threshold. The factory default is disabled.
Specify the data rate at which storm control activates. The value is a percentage of port
speed and ranges from 0-100.The factory default is 5 percent of port speed.
Selects the Link Aggregation Control Protocol administration state:
• Enable: Specifies that the port is allowed to participate in a port channel (LAG), which
is the default mode.
• Disable: Specifies that the port cannot participate in a port channel (LAG).
Software User Manual
115.
"Multiple Port Mirroring" on page
"Creating Port Channels (Trunking)" on
"Configuring Spanning Tree Protocol" on page
Document 34CSFP6XXUWS-SWUM100-D7
12/10/09
115.
246.