Rip Route Redistribution Configuration; Figure 204: Rip Route Redistribution Configuration; Table 185: Rip Route Redistribution Configuration Fields - D-Link DWS-4026 User Manual

Software User Manual
12/10/09
Field
Receive Version
RIP Admin Mode
Link State
• Click Refresh to update the information on the screen.
RIP R R
OUTE EDISTRIBUTION
Use the RIP Route Redistribution Configuration page to configure which routes are redistributed to other routers using RIP.
The allowable values for each fields are displayed next to the field. If any invalid values are entered, an alert message is
displayed with the list of all the valid values.
To display the page, click LAN > L3 Features > RIP > Route Redistribution Configuration in the navigation menu.
Field
Configured Source
Available Source
Document 34CSFP6XXUWS-SWUM100-D7
Table 184: RIP Interface Summary Fields (Cont.)
Description
Specifies which RIP version control packets are accepted by the interface. The default
is Both. Possible values are:
• RIP-1: only RIP version 1 formatted packets are received.
• RIP-2: only RIP version 2 formatted packets are received.
• Both: packets are received in either format.
• None: no RIP control packets are received.
Specifies whether RIP is Enabled or Disabled on the interface.
Specifies whether the RIP interface is up or down.
C
ONFIGURATION

Figure 204: RIP Route Redistribution Configuration

Table 185: RIP Route Redistribution Configuration Fields

Description
If any Source Routes have already been configured for redistribution by RIP, they
appear in the dropdown menu. Otherwise, the only available option is Create, which
allows you to configure an available source route. Select an existing route to view or
modify its parameters.
The dropdown menu is populated by only those Source Routes that have not
previously been configured for redistribution by RIP. This field is available only if you
select Create as the Configured Source. Possible values are:
• Static: The route was manually configured.
• Connected: The route was determined automatically because the host is directly
connected.
• RIP: The route was determined through RIP.
D-Link Unified Access System
Configuring RIP Page 297