Installing and Removing Memory
Caution: The memory is NOT hot swappable. Before removing or replacing any memory DIMM,
you must first take the server out of service, turn off all peripheral devices connected to
the system, turn off the system by pressing the power button, and unplug the AC power
cord from the system or wall outlet.
The silkscreen on the board for the DIMMs displays DIMM A1, DIMM A2, DIMM B1,
and DIMM B2 starting from the center of the board. See
discussion of the memory requirements and options. See
page x
for a link to the list of tested DIMMs.
Installing DIMMs
To install DIMMs, follow these steps:
1. Observe the safety and ESD precautions at the beginning of this book. See
Information" on page
2. Power down the server and unplug all peripheral devices and the AC power cable.
3. Remove the server system cover. For instructions, see
System Cover" on page
34
Figure 23. Installing the Processor Air Duct (SR1530HAHLX)
iii.
28.
Intel
®
Server System SR1530AH / SR1530AHLX / SR1530HAHLX
AF001581
"Memory" on page 17
"Server System References" on
"Removing the Server
for a
"Safety