Configuring Service Interface Pools (Nsm Procedure); Table 265: Virtual Interface Configuration Details - Juniper NETWORK AND SECURITY MANAGER 2010.3 - M-SERIES AND MX-SERIES DEVICES GUIDE REV1 Manual

Configuring Service Interface Pools (NSM Procedure)

Copyright © 2010, Juniper Networks, Inc.

Table 265: Virtual Interface Configuration Details

Task
Configure a virtual interface
You can configure service interface pools used for Virtual Private Network (VPN)
aggregation using the Service Interface Pools option. Up to 1000 logical interfaces can
be configured in a service interface pool. All interfaces in a pool must belong to the same
service PIC or DPC. All interfaces assigned to the same service must be in the same pool.
To configure service interface pools in NSM:
In the navigation tree select Device Manager > Devices.
1.
In the Devices list, double-click the device to select it.
2.
In the Configuration tab, expand Services.
3.
Select Service Interface Pools.
4.
Add or modify the settings as specified in Table 266 on page 456.
5.
Click one:
6.
OK—To save the changes.
Cancel—To cancel the modifications.
Your Action
1. Click Add new entry next to Virtual Interface.
2. In the Name box, enter the identifier number for the interface.
Range: 0 through 1023
3. In the Comment box, enter the comment.
4. From the Service State list, select the service state of the
virtual interface.
5. In the Interface box, enter the interface name.
6. Expand virtual-interface.
7. Click Media Service next to virtual-interface.
8. Click Add new entry next to Media Service.
9. In the dialog box, enter the identifier for the media service
name.
10. Click Routing Instance next to virtual-interface.
11. In the Comment box, enter the comment.
12. From the Routing Instance Name list, select the name of a
routing instance.
13. In the Service Interface box, enter the name and logical
interface number of the service Interface in
interface-name.unit-number form.
Chapter 23: Configuring Services
455