Monitoring Pim Settings - Juniper JUNOSE 11.0.X MULTICAST ROUTING Configuration Manual

JUNOSe 11.0.x Multicast Routing Configuration Guide
undebug ipv6 pim

Monitoring PIM Settings

You can use the show ipv6 pim commands to display information about PIM settings.
show ipv6 pim
232
Monitoring PIM
Use to turn off the display of information previously enabled with the debug
ipv6 pim command.
Example
host1#undebug ipv6 pim events
There is no no version.
See undebug ipv6 pim.
Use to view general PIM router-level information.
Field descriptions
Default PIM Version Default PIM version number (always 2)
Default Domain Id Default Domain Id (always 0)
Default Hello period Default interval (in minutes) at which the router sends
hello messages to neighbors
Default Hello Hold Time Default time (in minutes) for which the router
keeps the neighbor state alive
Join-Prune Interval Interval value (in seconds) set in the join/prune message
originated by the PIM router
Join-Prune Holdtime
message originated by the PIM router. The hold time is 3.5 times the PIM
join/prune message interval value.
Keepalive Period Time SG join state is maintained in the absence of SG
Join message
Assert Time Period after last assert before assert state is timed out
Register Suppression Time Period during which a designated router stops
sending registers to the RP
Register Probe Time Time before register suppression time (RST) expires
when a designated router might send a NULL-Register to the RP
Register TTL TTL value (in PIM register packets) originated by this PIM
router
SSM State of SSM on this PIM router (enabled or disabled)
range Default SSM group range or name of the access list specifying the
range
Hold time value (in seconds) set in the join/prune