Juniper JUNOSE 11.0.X MULTICAST ROUTING Configuration Manual page 58

JUNOSe 11.0.x Multicast Routing Configuration Guide
show ip multicast protocols
36
Monitoring IP Multicast Settings
RPF Iif Type and identifier for the incoming interface for the RPF route
#Oifs Number of outgoing interfaces
Counts Numbers of types of (S,G) pairs
(S,G) Number of (S,G) entries
(*,G) Number of (*,G) entries
Example
host1#show ip mroute summary
IP Multicast Routing Table
Group Address Source Address
--------------- --------------- ---------
224.0.1.39 52.1.1.1
224.0.1.40 51.1.1.1
Counts: 2 (S, G) entries
0 (*, G) entries
See show ip mroute.
Use to display information about multicast protocols enabled on the router.
Use the brief option to display a summary of information rather than a detailed
description.
Field descriptions
Multicast Protocols Multicast protocols on this router
Protocol Name of the multicast protocol
Type Mode of the multicast protocol
For DVMRP Dense
For PIM Sparse, Dense, or Sparse-Dense
For IGMP Local
Interfaces
registered Number of interfaces on which the protocol is configured
owned Number of interfaces that a protocol owns. If you configure
only IGMP on an interface, IGMP owns the interface. However, if you
configure IGMP and either PIM or DVMRP on the same interface, PIM
or DVMRP owns the interface.
Registered interfaces Information about interfaces on which the protocol
is configured:
RPF route RPF Iif
-------------
51.1.1.1/32 Register IIF
51.1.1.1/32 loopback1
#Oifs
----
0
1