Activating Multicast Qos Adjustment Functions; Figure 3: Multicast Traffic Receipt Without Forwarding - Juniper JUNOSE 11.0.X MULTICAST ROUTING Configuration Manual

NOTE: Ensure that PIM-SM (or any other upstream multicast protocol) is informed
of the group (or source-group) interest.

Figure 3: Multicast Traffic Receipt Without Forwarding

Activating Multicast QoS Adjustment Functions

The ip multicast-routing bandwidth-map command activates the specified
bandwidth map. By activating the bandwidth map, this command also activates the
multicast QoS adjustment function contained in the bandwidth map.
CAUTION: To activate multicast QoS adjustment, you must first create a bandwidth
map. See "Defining a Multicast Bandwidth Map" on page 10 for details.
ip multicast-routing bandwidth-map
Use to activate the QoS adjust function on the router.
Example
host1(config)#ip multicast-routing bandwidth-map mcast-bandwidths
Use the no version to disable the multicast QoS adjustment function on the
router.
See ip multicast-routing bandwidth-map.
Chapter 1: Configuring IPv4 Multicast

Activating Multicast QoS Adjustment Functions

17