Juniper JUNOSE 11.0.X MULTICAST ROUTING Configuration Manual page 89

show ip igmp interface brief
Counts: 0 down, 0 init state, 1 querier, 0 non-querier, 1 Total
Counts: 0 down, 0 init state, 1 querier, 0 non-querier, 1 Total
Example 2
host1#show ip igmp interface gigabitEthernet 3/0.0
Interface GigabitEthernet3/0.0 address 10.1.1.1/255.255.255.0
Administrative state enabled, Operational state disabled
Interface parameters:
Version 2
State Down
Query Interval 125 secs
Other querier present interval 250 secs
Maximum response time 100 (in 10ths of a second)
Last member query interval 10 (in 10ths of a second)
Robustness 3
Interface defaults to global promiscuous mode
No inbound access group
No inbound access source-group
No inbound apply-oif-map
Immediate Leave: disabled
Explicit Host Tracking: enabled
Max-Group limit: No Limit
Admission-Bandwidth limit: No Limit
Group Count: 0
IOA packet replication gigabitEthernet 3/8.1
Interface statistics:
Rcvd: 0 reports, 0 leaves, 0 wrong version queries
Sent: 0 queries
Groups learned: 0
See show ip igmp interface.
Use to display a summary of IGMP information for interfaces on which you
enabled IGMP.
Field descriptions
Interface Type of interface and interface specifier. For details about interface
types and specifiers, see Interface Types and Specifiers in JUNOSe Command
Reference Guide.
Intf Address IP address of the interface
Ver IGMP version
State Function of the interface: querier or nonquerier
Querier IP address of the querier on the network to which this interface
connects
QTime Time interval, in seconds, at which this interface sends query
messages
Chapter 2: Configuring IGMP
67
Monitoring IGMP