Monitoring Pim; Monitoring Pim Events - Juniper JUNOSE 11.0.X MULTICAST ROUTING Configuration Manual

clear ipv6 pim remote-neighbor

Monitoring PIM

You can display information about PIM events and parameters.

Monitoring PIM Events

You can use the debug PIM commands to view information about PIM events.
debug ipv6 pim
Use to clear the counters for multicast packet statistics on all interfaces or a
specified interface.
Specify an interface type and identifier, such as atm 3/0 to clear the counters on
that interface. For details about interface types and specifiers, see Interface Types
and Specifiers in JUNOSe Command Reference Guide.
If you do not specify an interface, the router clears the counters on all interfaces.
Example
host1#clear ipv6 pim interface atm 3/0.5 count
There is no no version.
See clear ipv6 pim interface.
Use to clear the counters for remote neighbor statistics on all interfaces or the
specified interface.
Specify the IP address of an interface to clear the counters for that interface.
If you do not specify an interface, the router clears the counters on all interfaces.
Example
host1#clear ipv6 pim remote-neighbor 1001::1 count
There is no no version.
See clear ipv6 pim remote-neighbor.
Use to show information about the selected event.
To control the type of events displayed, specify a severity level.
To control how much information to display, specify a verbosity level.
Example
host1#debug ipv6 pim events severity 1 verbosity low
Use the no version to disable the display.
See debug ipv6 pim.
Chapter 7: Configuring PIM for IPv6 Multicast

Monitoring PIM

231