Juniper JUNOSE 11.0.X MULTICAST ROUTING Configuration Manual page 134

JUNOSe 11.0.x Multicast Routing Configuration Guide
show ip pim auto-rp
112
Monitoring PIM
Join-Prune Holdtime
messages originated by the PIM router. The hold time is 3.5 times the PIM
join/prune message interval value.
Keepalive Period Time SG join state is maintained in the absence of SG
Join message
Assert Time Period after last assert before assert state is timed out
Register Suppression Time Period during which a designated router stops
sending registers to the RP
Register Probe Time Time before register suppression time (RST) expires
when a designated router might send a NULL-Register to the RP
Register TTL TTL value (in PIM register packets) originated by this PIM
router
SSM State of SSM on this PIM router (enabled or disabled)
range Default SSM group range or name of the access list specifying the
range
Sparse-Mode Graceful Restart Duration Restart interval in seconds
Join filter Name of the join filter access-list (if configured) for this PIM router
Designated Router Priority Designated router priority value
Example
host1:1#show ip pim
Default PIM Version: 2
Default Domain Id: 0
Default Hello Period: 30
Default Hello HoldTime: 105
Join-Prune Interval: 100
Join-Prune Holdtime: 350
Keepalive Period: 210
Assert Time: 210
Register Suppression Time: 60
Register Probe Time: 5
Register TTL: 64
SSM enabled, range default
Sparse-Mode Graceful Restart Duration: 30
Graceful restart is complete (timer 0 seconds)
Join filter, access-list bronze
Designated Router Priority: 2
See show ip pim.
Use to display information about RP routers and the RP mapping agent in a PIM
sparse mode environment.
Field descriptions
Hold time value (in seconds) set in the join/prune