Juniper JUNOSE 11.0.X MULTICAST ROUTING Configuration Manual page 84

JUNOSe 11.0.x Multicast Routing Configuration Guide
NOTE: The E120 and E320 routers output for monitor and show commands is
identical to output from other E Series routers, except that the E120 and E320 routers
output also includes information about the adapter identifier in the interface specifier
(slot/adapter/port).
baseline ip igmp
show ip igmp
62
Monitoring IGMP
Use to set the counters for IGMP statistics to zero, to establish a baseline.
Example
(host1)#baseline ip igmp
There is no no version.
See baseline ip igmp.
Use to display IGMP information for a VR.
Field descriptions
Routing Process Routing process for this VR (IGMP)
Administrative state Status of IGMP in the software: enabled or disabled
Operational state Status of IGMP on the VR: enabled or disabled
Total interfaces Number of interfaces on which you started IGMP
enabled Number of interfaces on which IGMP is enabled
disabled Number of interfaces on which IGMP is disabled
learnt groups Number of multicast groups that the VR has discovered
IGMP graceful restart duration Restart interval in seconds
IGMP Statistics Rcvd Statistics for IGMP messages received
total Total number of IGMP messages received
checksum errors Number of IGMP messages received with checksum
errors
unknown types Number of IGMP messages received that are not group
membership queries, group membership reports, or leave group
membership messages
queries Number of group membership queries
reports Number of group membership reports
leaves Number of leave group membership messages
IGMP Statistics Sent Statistics for IGMP messages sent