Juniper JUNOSE 11.0.X MULTICAST ROUTING Configuration Manual page 212

JUNOSe 11.0.x Multicast Routing Configuration Guide
ipv6 mld querier-timeout
ipv6 mld query-interval
ipv6 mld query-max-response-time
190
Configuring MLD Settings for an Interface
Use the no version to restore the default, 10-tenths of a second (1 second).
See ipv6 mld last-member-query-interval.
Use to set the time, in the range 1–400 seconds, that the interface waits for
queries from the current querier before sending query messages to assume
responsibility of querier.
Example
host1:boston(config-if)#ipv6 mld querier-timeout 200
Use the no version to set the time to the default, twice the query interval.
See ipv6 mld querier-timeout.
Use to specify how often, in the range 1–300 seconds, the interface sends group
membership queries.
Use the MLD-Query-Interval RADIUS attribute (VSA 26-98) in RADIUS
Access-Accept messages as an alternative method of configuring this value. The
RADIUS setting takes precedence over a CLI setting.
Example
host1:boston(config-if)#ipv6 mld query-interval 100
Use the no version to set the polling interval to the default, 125 seconds.
See ipv6 mld query-interval.
Use to specify the period in tenths of a second during which the host is expected
to respond to a group membership query. The possible period ranges are as
follows:
IGMPv1 and IGMPv2: 1–255 tenths of a second
IGMPv3: 1–31744 tenths of a second
MLDv1 and MLDv2 include this value in MLD query messages sent out on the
interface.
Using a lower value allows members to join and leave groups more quickly.
Use the MLD-Query-Max-Resp-Time RADIUS attribute (VSA 26-99) in RADIUS
Access-Accept messages as an alternative method of configuring this value. The
RADIUS setting takes precedence over a CLI setting.
Example
host1:boston(config-if)#ipv6 mld query-max-response-time 120