Juniper JUNOSE 11.0.X MULTICAST ROUTING Configuration Manual page 136

JUNOSe 11.0.x Multicast Routing Configuration Guide
show ip pim data-mdt
114
Monitoring PIM
expires in If BSR is not this router, time until the elected BSR expires if no
bootstrap messages are received
Local candidate RP mapping(s) Routers that the mapping agent is evaluating
to determine an RP router for this interface
Example 1 On a router that is the elected BSR
host1:1#show ip pim bsr
This PIM router is a Candidate BSR.
Configured on intf ATM3/0.101, address: 101.0.0.1
hashMaskLen 30, priority 2, period 60 seconds.
Elected BSR is this router, next BSM in 3 seconds.
Local candidate RP mapping(s):
Candidate RP 101.0.0.1
224.0.0.0/4, BSR, hold-time 150, interval 60, priority 192
228.0.0.0/24, BSR, hold-time 150, interval 60, priority 192, from
access-list acl
230.0.0.0/24, BSR, hold-time 150, interval 60, priority 192, from
access-list acl
Example 2 On a router that is a candidate BSR
host1:1#show ip pim bsr
This PIM router is a Candidate BSR.
Configured on intf ATM3/0.100, address: 100.0.0.1
hashMaskLen 30, priority 2, period 60 seconds.
Elected BSR is 101.0.0.1 (priority 0), expires in 73 seconds.
Example 3 On a router that is not a candidate BSR
host1:1#show ip pim bsr
This PIM router is not a Candidate BSR.
Elected BSR is 101.0.0.1 (priority 0), expires in 73 seconds.
See show ip pim bsr.
Use to display information about active data MDTs.
To display information about data MDTs on which the provider edge transmits
data, use the sender keyword.
To display information about data MDTs on which the provider edge receives
data, use the receiver keyword.
To display information about an IP PIM group address pool, use the group
keyword.
To display a summary of configuration for each data MDT, use the summary
keyword.
To display the number of data MDTs, use the count keyword.
Field descriptions