Juniper JUNOSE 11.0.X MULTICAST ROUTING Configuration Manual page 55

show ip mroute active
QoS bandwidth: 1998000 bps (adaptive)
RPF route: 10.0.0.0/8, incoming interface ATM2/1.200
neighbor 21.1.1.1, owner Netmgmt
Incoming interface list:
ATM2/1.200 (21.2.2.2/8), Accept/Pim (RPF IIF)
Outgoing interface list:
ATM2/1.300 (31.2.2.2/8), Blocked (port-adm-limit)/Pim, 0
00:00:23/never
Counts: 1 (S, G) entries
0 (*, G) entries
See show ip mroute.
Use to display the active multicast routes with admission bandwidth greater than
the specified bandwidth threshold.
The default is 4000 bps.
Field descriptions
See the show ip mroute command and the show ip mroute summary
command for descriptions of all fields.
Example 1 Displays active multicast routes with bandwidth above 10000 bps
host1#show ip mroute active 10000
Active IP Multicast Routes >=10000 bps
(S, G) uptime d h:m:s[, expires d h:m:s]
[Admission bandwidth: bps]
[QoS bandwidth: bps]
RPF route: addr/mask, incoming interface
neighbor address, owner route-owner
Incoming interface list:
Interface (addr/mask), State/Owner [(RPF IIF)]
Outgoing interface list:
Interface (addr/mask), State/Owner, Uptime/Expires
(52.0.0.1, 232.0.0.1) uptime 0 00:01:07
Admission bandwidth: 47000 bps (adaptive)
QoS bandwidth: 47000 bps (adaptive)
RPF route: 52.0.0.0/24, incoming interface ATM2/1.17
neighbor 17.0.0.2, owner NetmgmtRpf
Incoming interface list:
ATM2/1.17 (17.0.0.2/24), Accept/Igmp (RPF IIF)
Outgoing interface list:
NULL
Counts: 1 (S, G) entries
0 (*, G) entries
Example 2 Displays the summary of active multicast routes
host1#show ip mroute summary active
Active IP Multicast Routes >=4000 bps
Chapter 1: Configuring IPv4 Multicast
Monitoring IP Multicast Settings
33