Juniper JUNOSE 11.0.X MULTICAST ROUTING Configuration Manual page 57

show ip mroute summary
Received Number of packets and bytes that the VR received for this
multicast route
Forwarded Number of packets and bytes that the VR has forwarded
for this multicast route
Rcvd on OIF Number of packets that the VR has received on the
outgoing interface (OIF) for this multicast route
Example
host1#show ip mroute statistics
IP Multicast Routing Table
(S, G) uptime d h:m:s[, expires d h:m:s]
[Admission bandwidth: bps]
[QoS bandwidth: bps]
RPF route: addr/mask, incoming interface
neighbor address, owner route-owner
Incoming interface list:
Interface (addr/mask), State/Owner [(RPF IIF)]
Outgoing interface list:
Interface (addr/mask), State/Owner, Uptime/Expires
(10.0.1.9, 225.1.1.1) uptime 0 00:00:23
Admission bandwidth: 2000000 bps
QoS bandwidth: 2000000 bps
RPF route: 10.0.0.0/8, incoming interface ATM2/1.200
neighbor 21.1.1.1, owner Netmgmt
Incoming interface list:
ATM2/1.200 (21.2.2.2/8), Accept/Pim (RPF IIF)
Outgoing interface list:
ATM2/1.300 (31.2.2.2/8), Blocked (port-adm-limit)/Pim, 0
00:00:23/never
Statistics:
Received : 23 pkts, 1472 bytes
Forwarded : 0 pkts, 0 bytes
Rcvd on OIF: 0 pkts
Counts: 1 (S, G) entries
0 (*, G) entries
See show ip mroute.
See statistics.
Use to display a summary of all or specified multicast routes.
Specify a multicast group IP address or both a multicast group IP address and a
multicast source IP address to display information about a particular multicast
forwarding entry.
Field descriptions
Group Address IP address of the multicast group
Source Address IP address of the multicast source
RPF route IP address and network mask of the RPF route
Chapter 1: Configuring IPv4 Multicast
Monitoring IP Multicast Settings
35