Juniper JUNOSE 11.0.X MULTICAST ROUTING Configuration Manual page 230

JUNOSe 11.0.x Multicast Routing Configuration Guide
show ipv6 mld ssm-mapping
show multicast group limit
208
Monitoring MLD
Use to display the mapped OIF to be assigned to a given map-name, group
address, and source address.
Field descriptions
OIF-MAP Name Name of the map requested
Group Address Multicast group IP address requested
Source Address Source IP address requested
Mapped OIF Join interface associated with the OIF map
Example
host1#show ipv6 mld oif-mapping OIFMAP ff3e::1 10::10
OIF Mapping
OIF-MAP Name : OIFMAP
Group Address : ff3e::1
Source Address : 10::10
Mapped OIF : ATM5/0.120
See show ipv6 mld oif-mapping.
Use to display the SSM mapping state and the source list mapping associated
with a multicast group address.
Field descriptions
SSM Mapping Status of SSM mapping on the interface (enabled or disabled)
Group Address Multicast group address requested
Source List List of sources mapped to the multicast group address
Example
host1:boston#show ipv6 mld ssm-mapping ff3e::1
SSM Mapping : Enabled
Group Address : ff3e::1
Source List : 2001::1
: 2001::2
See show ipv6 mld ssm-mapping.
Use to display the number of MLD groups that ports have accepted and, if
configured, the maximum number of groups that ports can accept.
A value of –1 indicates that no port group limit is configured.
Only ports that have accepted MLD groups and ports for which you have
configured a limit for the number of MLD groups appear in this display.
Field descriptions
Port Identifier of the port in slot/port format