Juniper JUNOSE 11.0.X MULTICAST ROUTING Configuration Manual page 160

JUNOSe 11.0.x Multicast Routing Configuration Guide
show ip dvmrp interface
138
Monitoring DVMRP
Reachable Routes:
route-hog-notification:
route-limit:
Send-S32-Prunes-Only:
unicastRoutingOnly:
Graceful Restart Duration:
Graceful Restart is:
Redistribution
dynamic-redistribution:
See show ip dvmrp.
Use to display DVMRP parameters for the specified interfaces.
Field descriptions
Interface Type and specifier of the interface connected to a source. For
details about interface types and specifiers, see Interface Types and Specifiers
in JUNOSe Command Reference Guide.
SourceAddress IP address of the interface or, for an unnumbered interface,
address of the loopback interface
Network/Mask Network and mask of the subnet on which the interface
resides
Received Bad Packets/RBdPk Number of bad packets received on this
interface
Received Bad Routes/RBdRt Number of bad routes received on this interface
Routes Sent/SntRt Number of bad routes advertised on this interface
Administrative State Configured state of DVMRP on this interface: enabled
or Disabled
Summary Address(es) Specific summary address or addresses that this
interface should advertise
auto-summary Status of automatic summarization: Enabled or Disabled
metric-offset in Number of hops by which the router increases a DVMRP
route advertised in incoming DVMRP reports
metric-offset out Number of hops by which the router increases a DVMRP
route advertised in outgoing DVMRP reports
announce-filter Routes advertised by the interface
accept-filter(s) Names of IP access lists that specify the sources for which
the interface accepts routes
Example 1
host1:v3#show ip dvmrp interface
Interface: ATM2/0.1
2
10000
7000
true
false
60
complete (timer 0 seconds)
None Configured
enabled