Juniper JUNOSE 11.0.X MULTICAST ROUTING Configuration Manual page 144

JUNOSe 11.0.x Multicast Routing Configuration Guide
show ip pim sparse-mode unicast-route
show ip pim spt-threshold
122
Monitoring PIM
<*, G>
<*, *, RP>: 0
See show ip pim sparse-mode sg-state.
Use to display the unicast routes that PIM sparse mode is using.
Field descriptions
Route IP address and network mask for the unicast route
RpfNbr RPF neighbor
Iif Incoming interface for the unicast route
Pref Preference value for the unicast route
Metric Value of metric for the unicast route (type of metric varies with the
unicast protocol)
Count of entries Number of unicast routes that PIM sparse mode is using
Example
host1:2#show ip pim sparse-mode unicast-route
PIM SM unicast route table information
Route
---------------------------------------------------------------------------
122.0.0.0 /255.0.0.0
Count of entries: 1
See show ip pim sparse-mode unicast-route
Use to display the threshold for switching to the shortest path tree at a PIM
designated router.
Field descriptions
Access List Name Name of the IP access list that specifies the groups to
which the threshold applies
SptThreshold (in kbps) Value at which PIM sparse mode switches from a
shared tree to an SPT. A value of infinity indicates that PIM sparse mode
never switches to an SPT.
Example
host1:2#show ip pim spt-threshold
Access List Name
-------------------------------------------------------
1
See show ip pim spt-threshold.
: 3
RpfNbr Iif
122.0.0.1
SptThreshold(in kbps)
infinity
Pref Metric
255 1