Juniper JUNOSE 11.0.X MULTICAST ROUTING Configuration Manual page 224

JUNOSe 11.0.x Multicast Routing Configuration Guide
10::11 oif-map OIFMAP ATM5/0.
121
Counts: 4 version-2, 0 version-1, 0 check state, 0 disabled
(4 total)
0 excluded
Source-groups: 6 included, 0 excluded
show ipv6 mld interface
202
Monitoring MLD
See show ipv6 mld groups.
Use to display MLD information for interfaces on which you enabled MLD.
Specify the brief keyword to see a summary of the information.
Specify the count keyword to see the number of MLD interfaces.
Field descriptions
Interface Type of interface and interface specifier. For details about interface
types and specifiers, see Interface Types and Specifiers in JUNOSe Command
Reference Guide.
address IPv6 link-local address of the interface
Administrative state Status of the interface in the software: enabled or
disabled
Operational state Physical status of the interface: enabled or disabled
Version MLD version
State Function of the interface: querier or nonquerier
Query Interval Time interval at which this interface sends query messages
Other querier present interval Time that the interface waits before declaring
itself as the querier
Maximum response time Time interval during which this interface expects
a host to respond
Graceful restart Status of graceful restart: active or complete
Last member query interval Time that this interface waits before sending
a new query to a host that sends a group leave message
Robustness Number of times this interface sends MLD messages
Information about IPv6 access lists configured with the ipv6 mld
access-group command
Inbound access group Access list specified
No inbound access group No access list specified
Information about IPv6 access lists configured with the ipv6 mld
access-source-group command
373