Juniper JUNOSE 11.0.X MULTICAST ROUTING Configuration Manual page 137

host1:PE1#show ip pim data-mdt senders summary
VRF S/R C-Group
---- ------- ---------
PE11 Sender 225.1.1.1
PE12 Sender 225.1.1.1
Counts: 2 senders, 0 receivers, total 3.
show ip pim dense-mode sg-state
PE Name Name of the PE
C-SG Address of the C-SG
P-SG Address of the P-SG
MTI Name of the dynamic IP tunnel on which the data MDT was created
Data rate/Threshold Rate and threshold of multicast data
Time until next MDT Join TLV Configured delay until next MDT Join TLV
Time until MDT Join TLV expires Configured delay until MDT Join TLV
expires
Time until switchover from default-MDT Configured delay until the data
MDT switches over to the default MDT
Example 1 Displays information about a data MDT sender
host1:PE1#show ip pim data-mdt 225.1.1.1
PE11 - Sender
C-SG: 10.11.0.100, 225.1.1.1
P-SG: 1.1.1.1, 235.0.1.1
MTI: TUNNEL gre:mvpn-dynamic-1
Data rate/Threshold: 10012/500 Kbps
Time until next MDT Join TLV: 25 seconds
Example 2 Displays information about a data MDT receiver
host1:PE1#show ip pim data-mdt 225.2.2.2
PE31 - Receiver
C-SG: 10.13.0.100, 225.2.2.2
P-SG: 3.3.3.3, 235.0.1.1
MTI: TUNNEL gre:mvpn-dynamic-3
Time until MDT Join TLV expires: 29 seconds
Example 3 Displays a summary of data MDT senders
C-Source P-Group
----------- ---------
10.11.0.100 235.0.1.1
10.12.0.100 235.0.1.2
Example 4 Displays the number of data MDT senders and receivers
host1:PE1#show ip pim data-mdt count
Counts: 2 senders, 1 receivers, total 3.
See show ip pim data-mdt.
Chapter 3: Configuring PIM for IPv4 Multicast
P-Source MTI
-------- ---------------
1.1.1.1 TUNNEL gre:mvpn-dynamic-1
1.1.1.1 TUNNEL gre:mvpn-dynamic-2
115
Monitoring PIM