Before You Begin; Enabling And Disabling Pim On A Vr - Juniper JUNOSE 11.0.X MULTICAST ROUTING Configuration Manual

NOTE: IETF drafts are valid for only 6 months from the date of issuance. They must
be considered as works in progress. Please refer to the IETF Web site at
http://www.ietf.org

Before You Begin

You can configure multicast on IPv4 and IPv6 interfaces.
For information about configuring IP interfaces, see Configuring IP in theJUNOSe IP,
IPv6, and IGP Configuration Guide. For information about configuring IPv6 interfaces,
see Configuring IPv6 in the JUNOSe IP, IPv6, and IGP Configuration Guide.
For information about configuring PIM on IPv4 interfaces, see "Configuring PIM for
IPv4 Multicast" on page 79.

Enabling and Disabling PIM on a VR

By default, PIM is disabled. To enable PIM on a VR:
1.
2.
3.
To disable PIM processing on a router, use the pim disable command.
ipv6 router pim
pim disable
for the latest drafts.
Enable multicast routing.
Create a VR, or access the VR context.
Create and enable PIM processing.
host1(config)#virtual-router boston
host1:boston(config)#ipv6 router pim
Use to create and enable PIM processing on a VR or to access Router
Configuration mode.
Example
host1:boston(config)#ipv6 router pim
Use the no version to remove PIM from the VR.
See ipv6 router pim.
Use to disable PIM processing. By default, PIM processing is enabled.
Example
host1:boston(config-router)#pim disable
Chapter 7: Configuring PIM for IPv6 Multicast

Before You Begin

219