Juniper JUNOSE 11.0.X MULTICAST ROUTING Configuration Manual page 225

Inbound access source-group Access list specified
No inbound access source-group No access list specified
Information about OIF maps configured with the ipv6 mld apply-oif-map
command
Inbound apply-oif-map Map name specified
No inbound apply-oif-map No map name specified
Immediate Leave Setting of the ipv6 mld immediate-leave command:
enabled or disabled
Explicit Host Tracking Setting of the ipv6 mld explicit-tracking command:
enabled or disabled
Max-Group limit Number of MLD groups that the interface can accept, as
configured with the ipv6 mld group limit command
Group Count Number of MLD groups that the interface has accepted
IOA packet replication Hardware multicast packet replication interface to
which egress multicast packets on this interface are redirected
Interface statistics Rcvd Information about MLD messages received on this
interface
reports Number of group multicast listener reports received
leaves Number of group multicast listener done messages received
wrong version queries Number of multicast listener queries received
from devices running a different version of MLD
Interface statistics Sent Number of MLD messages this interface has sent
Interface statistics Groups learned Number of groups this interface has
discovered
Counts Total number of MLD interfaces
Example
host1:boston#show ipv6 mld interface
Interface ATM2/0.103 address 13.0.0.1/255.255.255.0
Administrative state enabled, Operational state enabled
Interface parameters:
Version 2
State Querier
Query Interval 125 secs, 125 secs before the next query
Other querier present interval 250 secs
Maximum response time 255 (in 10ths of a second)
Last member query interval 10 (in 10ths of a second)
Robustness 3
No inbound access group
No inbound access source-group
No inbound apply-oif-map
Immediate Leave: disabled
Chapter 6: Configuring Multicast Listener Discovery
Monitoring MLD
203