Juniper JUNOSE 11.0.X MULTICAST ROUTING Configuration Manual page 54

JUNOSe 11.0.x Multicast Routing Configuration Guide
NOTE: The (S,G) entry (1.1.1.1, 225.1.1.1) is the permanent mroute.
32
Monitoring IP Multicast Settings
Example 1 Constant bandwidth bit rate
host1#show ip mroute
IP Multicast Routing Table
(S, G) uptime d h:m:s
[Data rate: Kbps]
[Admission bandwidth: bps]
[QoS bandwidth: bps]
RPF route: addr/mask, incoming interface
neighbor address, owner route-owner
Incoming interface list:
Interface (addr/mask), State/Owner [(RPF IIF)]
Outgoing interface list:
Interface (addr/mask), State/Owner, Uptime/Expires
(10.0.10.1, 225.1.1.1) uptime 0 00:10:31
Data rate: 2132 Kbps, Threshold 500 Kbps
Admission bandwidth: 2000000 bps
RPF route: 10.0.10.0/24, incoming interface atm5/3.1010
neighbor 10.0.10.8, owner Local
Incoming interface list:
atm5/3.1010 (10.0.10.8/24), Accept/Pim (RPF IIF)
Outgoing interface list:
atm5/1.108 (108.0.8.5/8), Forward/Pim, 0 00:02:52/never
atm5/1.109 (107.0.8.4/8), Forward/Pim, 0 00:10:07/never
(1.1.1.1, 225.1.1.1) uptime 0 00:00:34, never expires
RPF route: 1.0.0.0/8, incoming interface ATM5/1.200
neighbor 2.2.2.2, owner Netmgmt
Incoming interface list:
ATM5/1.200 (2.1.1.1/8), Accept/Igmp (RPF IIF)
Outgoing interface list:
ATM5/1.300 (3.1.1.1/8), Forward/Igmp, 0 00:00:34/never
Counts: 2 (S, G) entries
0 (*, G) entries
Example 2 Adaptive bandwidths enabled
Host1#show ip mroute
IP Multicast Routing Table
(S, G) uptime d h:m:s[, expires d h:m:s]
[Admission bandwidth: bps]
[QoS bandwidth: bps]
RPF route: addr/mask, incoming interface
neighbor address, owner route-owner
Incoming interface list:
Interface (addr/mask), State/Owner [(RPF IIF)]
Outgoing interface list:
Interface (addr/mask), State/Owner, Uptime/Expires
(10.0.1.9, 225.1.1.1) uptime 0 00:00:23
Admission bandwidth: 1998000 bps (adaptive)
[SPT Threshold: Kbps] [Threshold: Kbps]