Juniper JUNOSE 11.0.X MULTICAST ROUTING Configuration Manual page 140

JUNOSe 11.0.x Multicast Routing Configuration Guide
show ip pim neighbor
118
Monitoring PIM
Example 2
host1#show ip pim interface summary
PIM Interface Summary
SM: 0, 0 enabled, 0 disabled
DM: 0, 0 enabled, 0 disabled
SM/DM: 1, 0 enabled, 1 disabled
Example 3
host1#show ip pim interface count
PIM Interface Count
Interface Addr Interface Name
192.32.10.20 ATM3/0.20
See show ip pim interface.
Use to display information about PIM neighbors that the router discovered.
Provide an interface type and specifier (such as atm 3/0) to display information
about that interface only. For details about interface types and specifiers, see
Interface Types and Specifiers in JUNOSe Command Reference Guide.
Field descriptions
Neighbor Addr IP address of the neighbor
Interface Name Type and specifier of the interface to which the neighbor
connects. For details about interface types and specifiers, see Interface Types
and Specifiers in JUNOSe Command Reference Guide.
Uptime Time since the router discovered this neighbor in days
hours:minutes:seconds format
Expires Time available for the neighbor to send a hello message to the
interface. If the neighbor does not send a hello message during this time, it
no longer is a neighbor.
Ver Version of PIM that the neighbor is running
Mode PIM mode that the neighbor is using: Sparse, Dense, or SparseDense
BFD BFD status: up or down
Example
host1#show ip pim neighbor
Neighbor
Addr Interface Name
-------- ---------------
1.1.1.1 FastEthernet1/1
Neighbor
Addr Interface Name
-------- ---------------
ControlPktCount In|Out
Hello JoinPrune
0 0
0 0
Uptime Expires Ver
-------- -------- ---
00:02:49 00:01:27 2
Uptime Expires Ver
-------- -------- ---
Assert
0
0
Mode BFD
------ ---
Sparse
Mode BFD
------ ---