References; Before You Begin; Enabling Dvmrp On A Vr - Juniper JUNOSE 11.0.X MULTICAST ROUTING Configuration Manual

JUNOSe 11.0.x Multicast Routing Configuration Guide
For information about modules that support DVMRP on the E120 and E320 Broadband
Services Routers:

References

For more information about DVMRP, see the following resource:

Before You Begin

You can configure multicasting on IPv4 and IPv6 interfaces.
For information about configuring IP interfaces, see Configuring IP in the JUNOSe IP,
IPv6, and IGP Configuration Guide. For information about configuring IPv6 interfaces,
see Configuring IPv6 in the JUNOSe IP, IPv6, and IGP Configuration Guide.
For information about configuring multicast on IPv6 interfaces, see "Configuring
IPv6 Multicast" on page 147.

Enabling DVMRP on a VR

By default, DVMRP is enabled on the router. To enable DVMRP on a VR:
1.
2.
NOTE: If you do not specify a VR, you can configure DVMRP on the default router.
You must enable and configure DVMRP on one or more interfaces for DVMRP to
function. See "Activating DVMRP on an Interface" on page 129. You can also set
DVMRP limits for the VR; see "Configuring DVMRP Limits" on page 129.
128

References

See E120 and E320 Module Guide, Table 1, Modules and IOAs for detailed module
specifications.
See E120 and E320 Module Guide, Appendix A, IOA Protocol Support for information
about the modules that support DVMRP.
Distance Vector Multicast Routing Protocol draft-ietf-idmr-dvmrp-v3-11.txt
(April 2004 expiration)
Enable multicast routing.
host1(config)#ip multicast-routing
(Optional) Create a VR or access a VR context.
host1(config)#virtual-router boston