Juniper JUNOSE 11.0.X MULTICAST ROUTING Configuration Manual page 59

show ip multicast protocols brief
Types and specifiers of interfaces. For details about interface types and
specifiers, see Interface Types and Specifiers in JUNOSe Command
Reference Guide.
Protocols configured on the interface and the protocol that owns the
interface. If you configure only IGMP on an interface, IGMP owns the
interface. However, if you configure IGMP and PIM or DVMRP on the
same interface, PIM or DVMRP owns the interface.
Admission-bandwidth Actual admission bandwidth/configured admission
bandwidth (in bps)
QoS Adjust Bandwidth of QoS adjustment, in bps
Count Number of multicast protocols on the VR
Active <S,G> count Number of active S,G data streams on the interface
Blocked <S,G> count Number of blocked S,G data streams on the interface
Example
host1#show ip multicast protocols
Multicast protocols:
Protocol Pim
Type: Sparse
Interfaces: 1 registered, 1 owned
Registered interfaces:
ATM2/1.103 (103.0.0.2/24) owner Pim
Protocol Igmp
Type: Local
Interfaces: 1000 registered, 1000 owned
Registered interfaces:
ATM2/0.131 (13.0.0.1/24) local Igmp owner Igmp
Admission-bandwidth 2000000/10000000 bps
QoS Adjust 2000000 bps
Active <S,G> count
Blocked <S,G> count
ATM2/0.132 (13.0.0.2/24) local Igmp owner Igmp
Admission-bandwidth 0/10000000 bps
QoS Adjust 0 bps
Active <S,G> count
Blocked <S,G> count
ATM2/0.133 (13.0.0.3/24) local Igmp owner Igmp
Admission-bandwidth 8000000/10000000 bps
QoS Adjust 0 bps
...
Count: 2 protocols
See show ip multicast protocols.
Chapter 1: Configuring IPv4 Multicast
15
10
25
10
Monitoring IP Multicast Settings
37