Enabling Pim On An Interface - Juniper JUNOSE 11.0.X MULTICAST ROUTING Configuration Manual

JUNOSe 11.0.x Multicast Routing Configuration Guide

Enabling PIM on an Interface

You can enable PIM on an interface in one of the PIM modes (dense, sparse, or
sparse-dense) and specify how often the interface sends hello messages to neighbors.
You can configure PIM and IGMP on the same interface. If you configure IGMP and
PIM on an interface, the router determines that PIM owns the interface.
NOTE: You cannot configure DVMRP and PIM on the same interface.
ip pim
ip pim query-interval
ip pim sparse-mode graceful-restart-duration
88

Enabling PIM on an Interface

Use the no version to reenable PIM processing.
See pim disable.
Use to enable PIM on an interface; dense mode is the default.
Example
host1(config-if)#ip pim sparse-dense-mode
Use the no version to disable PIM on an interface.
See ip pim.
Use to specify the interval, in seconds, at which the router sends hello messages
to neighbors.
Example
host1(config-if)#ip pim query-interval 100
Use the no version to restore the default setting, 30 seconds.
See ip pim query-interval.
Use to set the graceful restart duration for IP PIM sparse mode.
Example
host1(config-if)#ip pim sparse-mode graceful-restart-duration 10
Use the no version to return to the default duration of 30 seconds.
See ip pim sparse-mode graceful-restart-duration.