Juniper JUNOSE 11.0.X MULTICAST ROUTING Configuration Manual page 139

host1# show ip pim interface
PIM Interface Table
Interface Addr Interface
101.0.0.1 ATM2/0.100
102.0.0.1 ATM2/0.101
103.0.0.1 ATM3/0.102
Specify the summary keyword to view the number of configured, enabled, and
disabled PIM dense mode, PIM sparse mode, and PIM sparse-dense mode
interfaces.
Specify the count keyword to view the number of multicast packets that the
interface has sent and received.
Field descriptions
Interface Addr IP address of the interface
Interface Name Type and specifier of the interface. For details about
interface types and specifiers, see Interface Types and Specifiers in JUNOSe
Command Reference Guide.
Ver Version of PIM running on this interface
Mode PIM mode running on this interface: Sparse, Dense, or SparseDense
Nbr Count Number of neighbors connected to this interface
Hello Intvl Time interval, in seconds, at which the interface sends hello
messages to neighbors
J/P Interval Time interval, in seconds, at which the interface sends the
join/prune messages
DR Addr Address of the designated router
SM Number of PIM sparse mode interfaces
DM Number of PIM dense mode interfaces
SM/DM Number of PIM sparse-dense mode interfaces
enabled Number of interfaces administratively enabled
disabled Number of interfaces administratively disabled
DR Pri Designated router priority value
ControlPktCount In|Out PIM messages received on and sent from this
interface
Hello Total number of hello messages
JoinPrune Total number of join and prune messages
Assert Total number of assert messages
Example 1
State Ver Mode Nbr
Count
Up 2 Sparse 1
Up 2 Sparse 1
Up 2 Sparse 1
Chapter 3: Configuring PIM for IPv4 Multicast
Hello J/P DR DR Addr
Intvl Intvl Pri
30 150 5 101.0.0.2
30 100 2 102.0.0.2
30 100 2 103.0.0.1
JoinFilter
-
silver
gold
117
Monitoring PIM