Configuring Ssm Mapping - Juniper JUNOSE 11.0.X MULTICAST ROUTING Configuration Manual

ipv6 mld oif-map
ipv6 mld version

Configuring SSM Mapping

SSM mapping enables the router to determine one or more source addresses for
group G. The mapping effectively translates an MLDv1 multicast listener report to
an MLDv2 report, enabling the router to continue as if it had initially received an
MLDv2 report. After the router is joined to these groups, it sends out PIM join
messages and continues to enable joining from these groups, as long as it continues
to receive MLDv1 membership reports and no change occurs to the SSM mapping
for the group.
When you statically configure SSM mapping, the router can discover source addresses
from a statically configured table.
host1(config-subif)#ipv6 mld apply-oif-map OIFMAP
Use the no version to remove the outgoing interface map association from the
interface.
See ipv6 mld apply-oif-map.
Use to create an OIF map.
Use the MLD-OIF-Map-Name RADIUS attribute (VSA 26-76) in RADIUS
Access-Accept messages as an alternative method of configuring this value.
Example
host1(config)#ipv6 mld oif-map OIFMAP atm 3/0.1 ff0e::1:1/128 2001::1:1/128
host1(config)#ipv6 mld oif-map OIFMAP atm 3/0.2 ff0e::1:1/128 2001::1:1/128
host1(config)#ipv6 mld oif-map OIFMAP atm 3/0.3 ff0e::1:1/128
host1(config)#ipv6 mld oif-map OIFMAP atm 3/0.4 ff0e::1:0/112 2001::1:1/128
host1(config)#ipv6 mld oif-map OIFMAP atm 3/0.5 ff0e::1:0/112 2001::1:1/128
host1(config)#ipv6 mld oif-map OIFMAP self ::/0 2001::1:0/112
Use the no version to remove an outgoing interface map attribute.
See ipv6 mld oif-map.
Use to set the MLD version (1 or 2) for the interface or specify a passive interface
with only multicast-data-forwarding capability (passive).
Use the MLD-Version RADIUS attribute (VSA 26-77) in RADIUS Access-Accept
messages as an alternative method of configuring this value.
Example
host1:dallas(config-if)#ipv6 mld version passive
Use the no version to set the version to the default, mldv2.
See ipv6 mld version.
Chapter 6: Configuring Multicast Listener Discovery

Configuring SSM Mapping

193