Configuring The Pim Join/Prune Message Interval - Juniper JUNOSE 11.0.X MULTICAST ROUTING Configuration Manual

override this global setting on a particular interface, use the ipv6 pim dr-priority
command in Interface Configuration mode.
NOTE: You cannot configure the designated router priority on PIM DM interfaces.
ipv6 pim dr-priority

Configuring the PIM Join/Prune Message Interval

When you use the router for PIM, the router sends join/prune message to the upstream
RPF neighbor. The default join/prune message interval is 60 seconds. You can
configure the join/prune message interval using the ipv6 pim join-prune-interval
command. The ipv6 pim join-prune-interval command in Router Configuration
mode configures the join-prune interval on all the PIM interfaces on the router. To
override this global setting on a particular interface, use the ipv6 pim
join-prune-interval command in Interface Configuration mode.
The hold-time associated with the PIM join/prune interval messages is 3.5 times the
PIM join/prune message interval.
NOTE: You cannot configure the PIM join/prune message interval on PIM dense mode
interfaces.
ipv6 pim join-prune-interval
Use to set a priority value, in the range 1–254, by which a router is likely to be
selected as the designated router.
Examples
In Router Configuration mode:
host1(config-if)#ipv6 pim dr-priority 24
In Interface Configuration mode:
host1(config-subif)#ipv6 pim dr-priority 24
Use the no version to restore the default value, 1.
Use to set an interval value, in the range 10–210 seconds, at which the router
sends the PIM join/prune message; the default value is 60 seconds.
Examples
In Router Configuration mode:
host1(config-if)#ipv6 pim join-prune-interval 150
Chapter 7: Configuring PIM for IPv6 Multicast

Configuring the PIM Join/Prune Message Interval

221