Table of Contents
Advertisement
JunosE 11.3.x Multicast Routing Configuration Guide
Monitoring PIM Settings
show ip pim
110
Use to turn off the display of information previously enabled with the debug ip pim
command.
Example
host1#undebug ip pim events
There is no no version.
See undebug ip pim.
You can use the show ip pim commands to display information about PIM settings.
Use to view general PIM router-level information.
Field descriptions
Default PIM Version—Default PIM version number (always 2)
Default Domain Id—Default Domain Id (always 0)
Default Hello period—Default interval (in minutes) at which the router sends hello
messages to neighbors
Default Hello Hold Time—Default time (in minutes) for which the router keeps the
neighbor state alive
Join-Prune Interval—Interval value (in seconds) set in the join/prune message
originated by the PIM router
Join-Prune Holdtime— Hold time value (in seconds) set in the join/prune messages
originated by the PIM router. The hold time is 3.5 times the PIM join/prune message
interval value.
Keepalive Period—Time SG join state is maintained in the absence of SG Join message
Assert Time—Period after last assert before assert state is timed out
Register Suppression Time—Period during which a designated router stops sending
registers to the RP
Register Probe Time—Time before register suppression time (RST) expires when a
designated router might send a NULL-Register to the RP
Register TTL—TTL value (in PIM register packets) originated by this PIM router
SSM—State of SSM on this PIM router (enabled or disabled)
range—Default SSM group range or name of the access list specifying the range
Sparse-Mode Graceful Restart Duration—Restart interval in seconds
Copyright © 2010, Juniper Networks, Inc.
Advertisement
Table of Contents
