Juniper JUNOSE 11.0.X MULTICAST ROUTING Configuration Manual page 142

JUNOSe 11.0.x Multicast Routing Configuration Guide
show ip pim sparse-mode sg-state
120
Monitoring PIM
Use to show which RP router that a multicast group is using.
Field descriptions
Group(s) Multicast group or groups
RP RP router for the multicast group
priority Priority of the router
via Method by which the RP router was assigned: AutoRP, Static RP, or
BSR
expiryTime Time in seconds at which the RP mapping becomes invalid,
unless it is renewed by the mapping agent
Example 1
host1:2#show ip pim rp-hash 232.1.1.1
Group(s) 224.0.0.0/4
RP 122.0.0.1, priority 0,
Example 2
host1:2#show ip pim rp-hash 226.0.0.1
Group(s) 226.0.0.0/24
RP 101.0.0.1, priority 192, via BSR, expires in 145 seconds
*RP 145.0.0.3, priority 192, via BSR, expires in 145 seconds
See show ip pim rp-hash.
Use to display information for each (S,G) pair for PIM sparse mode and PIM SSM.
Field descriptions
(S, G) pair Source, Group pair for which information is provided
Group-to-RP mapping IP addresses and network mask of the multicast
group
RP IP address of RP router
SSM group Indicator that this is an SSM group
RPF Route IP address and network mask of the RPF route
IIF IP address of the incoming interface for the RPF route
UpNbr IP address of the upstream neighbor
Oifs Outgoing interface
Auto RP Discovery SELF oif Indicates that RP router for this group was
assigned through auto-RP
Register Oif to RP IP address of RP router for the outgoing interface;
suppressed for SSM
via AutoRP, expiryTime 128