Juniper JUNOSE 11.0.X MULTICAST ROUTING Configuration Manual page 259

show ipv6 pim rp
show ipv6 pim rp-hash
In interface Type and identifier of the interface on which PIM router receives
packets from remote neighbor. For details about interface types and
specifiers, see Interface Types and Specifiers in JUNOSe Command Reference
Guide.
Out interface Type and identifier of the interface on which PIM router sends
packets to remote neighbor. For details about interface types and specifiers,
see Interface Types and Specifiers in JUNOSe Command Reference Guide.
Example
host1:boston#show ipv6 pim remote-neighbor
PIM RemoteNbr Table
RemoteNbr Addr OurEnd Addr
1001::1 2001::1
In interface : atm2/1.109
Out interface: atm2/1.108
See show ipv6 pim remote-neighbor
Use to display information about PIM group-to-RP mappings.
Specify the address of a group to view PIM group-to-RP mappings for a particular
group.
To display all group-to-RP mappings that the router has recorded, specify the
mapping keyword.
Field descriptions
Group Prefix of the multicast group
RP IP address of RP router for the multicast group
priority This field is not functional
via Method by which the RP router was assigned (static, BSR)
Example
host1:8#show ipv6 pim rp mapping
PIM Group-to-RP mapping(s)
Group(s) ff00::/12
RP ::122:1, priority 0,
Group(s) ff0e::1:0/96
RP ::120:1, priority 0,
See show ipv6 pim rp
Use to show which RP router a multicast group is using.
Field descriptions
Chapter 7: Configuring PIM for IPv6 Multicast
Ver Mode Nbr
Count Intvl
2 Sparse 1
via static
via static
Monitoring PIM
Hello DR Addr
30 ::107:84
237