Juniper JUNOSE 11.0.X MULTICAST ROUTING Configuration Manual page 36

JUNOSe 11.0.x Multicast Routing Configuration Guide
1.
2.
NOTE: You can also define a prefix-list or a prefix-tree for use by the match ip
address command to match (S,G) and (*,G) entries.
For additional information about configuring QoS adjustment, see "Configuring
Multicast QoS Adjustment" on page 15.
For additional information about configuring interface-level and port-level admission
control, see "Blocking and Limiting Multicast Traffic" on page 25.
For additional information about creating route maps, see JUNOSe IP Services
Configuration Guide .
set admission-bandwidth
set priority
14
Defining a Multicast Bandwidth Map
Define a route-map using the set admission-bandwidth and set qos-bandwidth
commands. You can optionally issue the set priority command.
host1(config)#route-map mcast-bandwidths permit 10
host1(config-route-map)#match ip address sdtv
host1(config-route-map)#set admission-bandwidth 2000000
host1(config-route-map)#set qos-bandwidth 2000000
host1(config-route-map)#set priority 100
host1(config-route-map)#route-map mcast-bandwidths permit 20
host1(config-route-map)#match ip address hdtv
host1(config-route-map)#set admission-bandwidth 10000000
host1(config-route-map)#set qos-bandwidth 10000000
host1(config-route-map)#set priority 200
host1(config-route-map)#end
Define the access list for use by the match ip address command to match (S,G)
and (*,G) entries.
host1(config)#access-list sdtv permit ip host 31.0.0.1 232.0.0.0 0.0.0.255
host1(config)#access-list hdtv permit ip host 32.0.0.1 232.0.0.0 0.0.0.255
host1(config)#access-list hdtv permit ip host 32.0.0.2 232.0.0.0 0.0.0.255
host1(config-route-map)#end
Use to set a multicast bandwidth for admission control.
Use the adaptive keyword to define the bandwidth as adaptive (automatically
sensed).
Example
host1(config-route-map)#set admission-bandwidth 2000000
Use the no version to remove the set clause from a route map.
See set admission-bandwidth.