Juniper JUNOSE 11.0.X MULTICAST ROUTING Configuration Manual page 197

Use to display the active multicast routes with admission bandwidth greater than
the specified bandwidth threshold.
The default is 4000 bps.
Field descriptions
See the show ipv6 mroute command and the show ipv6 mroute summary
command for descriptions of all fields.
Example 1 Displays active multicast routes with bandwidth above 10000 bps
host1#show ipv6 mroute active 10000
Active IP Multicast Routes >=10000 bps
(S, G) uptime d h:m:s[, expires d h:m:s]
[Admission bandwidth: bps]
[QoS bandwidth: bps]
RPF route: addr/mask, incoming interface
neighbor address, owner route-owner
Incoming interface list:
Interface (addr/mask), State/Owner [(RPF IIF)]
Outgoing interface list:
Interface (addr/mask), State/Owner, Uptime/Expires
(52::1, ff3e::1) uptime 0 00:01:07
Admission bandwidth: 47000 bps (adaptive)
QoS bandwidth: 47000 bps (adaptive)
RPF route: 52::/112, incoming interface ATM2/1.17
neighbor 17::2, owner NetmgmtRpf
Incoming interface list:
ATM2/1.17 (fe80::90:1a00:3140:1ff8/128), Accept/MLD (RPF IIF)
Outgoing interface list:
NULL
Counts: 1 (S, G) entries
0 (*, G) entries
Example 2 Displays the summary of active multicast routes
host1#show ipv6 mroute summary active
Active IP Multicast Routes >=4000 bps
Chapter 5: Configuring IPv6 Multicast
Monitoring IPv6 Multicast Settings
175