Juniper JUNOSE 11.0.X MULTICAST ROUTING Configuration Manual page 93

show ip igmp ssm-mapping
show multicast group limit
OIF-MAP Name Name of the map requested
Group Address Multicast group IP address requested
Source Address Source IP address requested
Mapped OIF Interface associated with the OIF map
Example
host1#show ip igmp oif-mapping OIFMAP 232.1.1.1 10.1.1.10
OIF Mapping
OIF-MAP Name : OIFMAP
Group Address : 232.1.1.1
Source Address : 10.1.1.10
Mapped OIF : ATM5/0.120
See show ip igmp oif-mapping.
Use to display the SSM mapping state and the source list mapping associated
with a multicast group address.
Field descriptions
SSM Mapping Status of SSM mapping on the interface: Enabled or Disabled
Group Address Multicast group address requested
Source List List of sources mapped to the multicast group address
Example
host1:boston#show ip igmp ssm-mapping 232.1.1.1
SSM Mapping : Enabled
Group Address : 232.1.1.1
Source List : 172.1.1.1
: 172.1.1.2
See show ip igmp ssm-mapping.
Use to display the number of IGMP groups that ports have accepted and, if
configured, the maximum number of groups that ports can accept.
A value of –1 indicates that no port group limit is configured.
Only ports that have accepted IGMP groups and ports for which you have
configured a limit for the number of IGMP groups appear in this display.
Field descriptions
Port Identifier of the port in slot/port format
slot Number of the chassis slot in the range 0–6 (ERX7xx models) and
0–13 (ERX14xx models)
Chapter 2: Configuring IGMP
71
Monitoring IGMP