Juniper JUNOSE 11.0.X MULTICAST ROUTING Configuration Manual page 202

JUNOSe 11.0.x Multicast Routing Configuration Guide
show ipv6 multicast protocols brief
180
Monitoring IPv6 Multicast Settings
interface. However, if you configure MLD and PIM on the same interface,
PIM owns the interface.
Admitted bandwidth / configured admission bandwidth (in bps)
Number of blocked OIFs
QoS adjustment bandwidth (in bps)
Count Number of multicast protocols on the VR
Example
host1:2#show ipv6 multicast protocols
Multicast protocols:
Protocol Pim
Type: Sparse
Interfaces: 1 registered, 1 owned
Registered interfaces:
ATM2/1.103 (21:2:2:22::1:2/60) owner Pim
Protocol Mld
Type: Local
Interfaces: 1000 registered, 1000 owned
Registered interfaces:
ATM2/0.131 (31:2:2:22::2:2/604) local Mld owner Mld
Admission-bandwidth 2000000/10000000 bps
QoS Adjust 2000 bps
ATM2/0.132 (31:2:2:22::2:3/60) local Mld owner Mld
Admission-bandwidth 0/10000000 bps
QoS Adjust 0 bps
ATM2/0.133 (31:2:2:22::2:4/60) local Mld owner Mld
Admission-bandwidth 8000000/10000000 bps, 2 Blocked OIFs
QoS Adjust 0 bps
...
Count: 2 protocols
See show ipv6 multicast protocols.
Use to display a summary of information about multicast protocols enabled on
the router.
Field descriptions
Protocol Name of the multicast protocol
Registered Interfaces Number of interfaces on which the protocol is
configured.
Owned Interfaces Number of interfaces that a protocol owns. If you
configure only MLD on an interface, MLD owns the interface. However, if
you configure MLD and PIM on the same interface, PIM owns the interface.
Type Mode of the multicast protocol
For PIM Sparse