Activating Multicast Qos Adjustment Functions; Configuring Hardware Multicast Packet Replication; Figure 16: Multicast Traffic Receipt Without Forwarding - Juniper JUNOSE 11.0.X MULTICAST ROUTING Configuration Manual

JUNOSe 11.0.x Multicast Routing Configuration Guide

Figure 16: Multicast Traffic Receipt Without Forwarding

Activating Multicast QoS Adjustment Functions

The ipv6 multicast-routing bandwidth-map command activates the specified
bandwidth map. By activating the bandwidth map, this command also activates the
multicast QoS adjustment function contained in the bandwidth map.
CAUTION: To activate multicast QoS adjustment, you must first create a bandwidth
map. See "Defining a Multicast Bandwidth Map" on page 154 for details.
ipv6 multicast-routing bandwidth-map

Configuring Hardware Multicast Packet Replication

You can configure IPv6 multicast to replicate packets to optimized hardware on a
logical port instead of using the forwarding controller (FC) on the router.
160
Activating Multicast QoS Adjustment Functions
Use to enable the QoS adjust function on the router.
Example
host1(config)#ipv6 multicast-routing bandwidth-map mcast-bandwidths
Use the no version to disable the multicast QoS adjustment function on the
router.
See ipv6 multicast-routing bandwidth-map.