Juniper JUNOSE 11.0.X MULTICAST ROUTING Configuration Manual page 30

JUNOSe 11.0.x Multicast Routing Configuration Guide
show ip rpf-route
8
Displaying Available Routes for Reverse-Path Forwarding
Use to display routes that the router can use for RPF.
Specify the IP address and the network mask to view routes to a particular
destination.
Specify a unicast routing protocol to view routes associated with that protocol.
Field descriptions
Prefix Value of the logical AND of the IP address of the destination network
and the subnet address
Length Length of the subnet mask in bits
Type Protocol type for the interface
Connect Subnet directly connected to the interface
Static Static route
protocol-name Route learned through the named protocol
Next Hop IP address of the next hop for this route
Dist Distance configured for this route
Met Learned or configured cost associated with this route
Intf Type of interface and interface specifier for the next hop. For details
about interface types and specifiers, seeInterface Types and Specifiers in
JUNOSe Command Reference Guide.
Example 1
host1#show ip rpf-route
Protocol/Route type codes:
I1- ISIS level 1, I2- ISIS level2,
I- route type intra, IA- route type inter, E- route type external,
i- metric type internal, e- metric type external,
O- OSPF, E1- external type 1, E2- external type2,
N1- NSSA external type1, N2- NSSA external type2
L- MPLS label, V- VR/VRF, *- indirect next-hop
Prefix/Length Type
------------- ----
10.10.0.112/32 Static
10.1.1.0/24 Connect 10.1.1.1
25.25.25.25/32 Connect 25.25.25.25
Example 2
host1#show ip rpf-route static
Protocol/Route type codes:
I1- ISIS level 1, I2- ISIS level2,
I- route type intra, IA- route type inter, E- route type external,
i- metric type internal, e- metric type external,
O- OSPF, E1- external type 1, E2- external type2,
N1- NSSA external type1, N2- NSSA external type2
L- MPLS label, V- VR/VRF, *- indirect next-hop
Next Hop Dist/Met
-------- --------
192.168.1.1 1/1
0/1
0/1
Intf
------
fastEthernet0/0
atm3/0.100
loopback0