Juniper JUNOSE 11.0.X MULTICAST ROUTING Configuration Manual page 56

JUNOSe 11.0.x Multicast Routing Configuration Guide
show ip mroute count
show ip mroute statistics
NOTE: The display shows statistics after the VR has added the multicast route to the
multicast routing table and established the route on the appropriate line module.
Statistics for interactions that take place before the route is established on the line
module are not displayed.
34
Monitoring IP Multicast Settings
Group Address Source Address
--------------- --------------- ------------------ --------------- -----
232.0.0.1 51.0.0.1
232.0.0.2 51.0.0.1
232.0.0.3 51.0.0.1
Counts: 3 (S, G) entries
0 (*, G) entries
See show ip mroute.
Use to display information about the number of groups and sources.
Specify a multicast group address or both a multicast group address and a
multicast source address to display information about a particular multicast
forwarding entry.
Field descriptions
Counts Number of types of source group mappings
(S, G) Number of (S,G) entries
(*, G) Number of (*,G) entries
Example
host1#show ip mroute count
IP Multicast Routing Table
Counts: 2 (S, G) entries
0 (*, G) entries
See show ip mroute.
Use to display statistics for packets received through multicast routes that the
router has added to the multicast routing table and established on the appropriate
line modules.
Specify a multicast group IP address or both a multicast group IP address and a
multicast source IP address to display information about a particular multicast
forwarding entry.
Field descriptions
See the show ip mroute command for descriptions of all fields except the
Statistics field.
Statistics
RPF route RPF Iif
51.0.0.0/24 ATM3/1.17
51.0.0.0/24 ATM3/1.17
51.0.0.0/24 ATM3/1.17
#Oifs
0
0
0