Juniper JUNOSE 11.0.X MULTICAST ROUTING Configuration Manual page 199

show ipv6 mroute statistics
NOTE: The display shows statistics after the VR has added the multicast route to the
multicast routing table and established the route on the appropriate line module.
Statistics for interactions before the route is established on the line module are not
displayed.
Field descriptions
Counts Number of types of source group mappings
(S,G) Number of (S,G) entries
(*,G) Number of (*,G) entries
Example
host1#show ipv6 mroute count
IPv6 Multicast Routing Table
Counts: 2000 (S, G) entries
0 (*, G) entries
See show ipv6 mroute.
Use to display statistics for packets received through multicast routes that the
router has added to the multicast routing table and established on the appropriate
line modules.
Specify a multicast group IPv6 address or both a multicast group IPv6 address
and a multicast source IPv6 address to display information about a particular
multicast forwarding entry.
Field descriptions
See show ipv6 mroute command for descriptions of all fields except the
statistics field.
Statistics
Received Number of packets and bytes that the VR received for this
multicast route
Forwarded Number of packets and statistics that the VR has forwarded
for this multicast route
Rcvd on OIF Number of packets and statistics that the VR has received
on the OIF for this multicast route
Example
host#show ipv6 mroute statistics
IPv6 Multicast Routing Table
(S, G) uptime d h:m:s[, expires d h:m:s]
[Admission bandwidth: bps]
[QoS bandwidth: bps]
Chapter 5: Configuring IPv6 Multicast
Monitoring IPv6 Multicast Settings
177