Juniper JUNOSE 11.0.X MULTICAST ROUTING Configuration Manual page 255

show ipv6 pim bsr
Join filter Name of the join filter access-list (if configured) for this PIM router
Designated Router Priority Designated router priority value
Example
host1:1#show ipv6 pim
Default PIM Version: 2
Default Domain Id: 0
Default Hello Period: 30
Default Hello HoldTime: 105
Join-Prune Interval: 100
Join-Prune Holdtime: 350
Keepalive Period: 210
Assert Time: 210
Register Suppression Time: 60
Register Probe Time: 5
Register TTL: 64
SSM enabled, range default
Sparse-Mode Graceful Restart Duration: 30
Graceful restart is complete (timer 0 seconds)
Join filter, access-list bronze
Designated Router Priority: 2
See show ipv6 pim.
Use to display BSR information and the group prefixes for which the local router
is a candidate RP in a PIM sparse mode environment.
Field descriptions
Candidacy Whether or not the router is a candidate BSR
Configured on Interface on which the router is configured
address Address of the router
hashMaskLen Hash mask length
priority Priority of the router
period Time between bootstrap messages
Elected BSR " this router" or IP address of the elected bootstrap router
next BSM If BSR is " this router," time until the next bootstrap message is
sent
expires in If BSR is not " this router," time until the elected BSR expires if
no bootstrap messages are received
Local candidate RP mapping(s) Routers that the mapping agent is evaluating
to determine an RP router for this interface
Example 1 On a router that is the elected BSR
host1:1#show ipv6 pim bsr
This PIM router is a Candidate BSR.
Chapter 7: Configuring PIM for IPv6 Multicast
Monitoring PIM
233