Figure 19: Static And Dynamic Mld Interfaces; Table 10: Static Mld Commands - Juniper JUNOSE 11.0.X MULTICAST ROUTING Configuration Manual

Figure 19: Static and Dynamic MLD Interfaces

Static MLD interfaces are configured with software such as the CLI or an SNMP
application; dynamic MLD interfaces are configured with a profile. A profile comprises
a set of attributes for an interface; a profile for dynamic MLD interfaces contains
attributes for configuring all the layers in the interface.
You define a profile by using the same CLI commands that you use to configure a
static MLD interface; however, the mode in which you use the commands differs.
Use the commands in Interface Configuration mode to configure a static MLD interface
and in Profile Configuration mode to define a profile.
When you have defined a profile, you can apply it to an interface or a group of
interfaces. Profiles provide an efficient method of creating and managing large
numbers of dynamic interfaces. For detailed information about creating and assigning
profiles, see Configuring Dynamic Interfaces in the JUNOSe Link Layer Configuration
Guide. When you create a profile for dynamic MLD interfaces, specify attributes for
configuring all layers in the interface.
You use the MLD commands shown in Table 10 on page 187 to configure a static
MLD interface. You also use these commands to define the attributes for the MLD
layer when you create a profile for dynamic MLD interfaces.

Table 10: Static MLD Commands

ipv6 mld
ipv6 mld access-group
ipv6 mld access-source-group
ipv6 mld explicit-tracking
ipv6 mld group limit
ipv6 mld immediate-leave
ipv6 mld last-member-query-interval
ipv6 mld querier-timeout
Chapter 6: Configuring Multicast Listener Discovery
ipv6 mld query-interval
ipv6 mld query-max-response-time
ipv6 mld robustness
ipv6 mld static-include
ipv6 mld static-exclude
ipv6 mld static-group
ipv6 mld version
Configuring Static and Dynamic MLD Interfaces
187