Juniper JUNOSE 11.0.X MULTICAST ROUTING Configuration Manual page 135

host1:1# show ip pim auto-rp
This PIM router is _not_ an Auto RP mapping agent.
PIM AutoRP candidate RP mapping(s)
Candidate RP 122.0.0.1
Group(s) 224.0.0.0/4, AutoRP, ttl 64, interval 60, from access List 1
Candidate RP 122.0.0.1
Group(s) 224.0.1.39/32 (negative), AutoRP, ttl 64, interval 60, from access List 1
Candidate RP 122.0.0.1
Group(s) 224.0.1.40/32 (negative), AutoRP, ttl 64, interval 60, from access List 1
show ip pim bsr
Configured with ttl Number of hops for which the RP discovery message
is valid
Using interface addr IP address of the interface from which the router sends
RP discovery messages
interval Time interval, in seconds, at which the router sends RP discovery
messages
PIM AutoRP candidate RP mapping(s) Routers that the RP mapping agent
is evaluating to determine an RP router for this interface
Example 1
host1:1#show ip pim auto-rp
This PIM router is an Auto RP mapping agent.
Configured with ttl 64
[ Using interface addr 121.0.0.1, interval 60 ].
PIM AutoRP candidate RP mapping(s)
Example 2
See show ip pim auto-rp.
Use to display BSR information and the group prefixes for which the local router
is a candidate RP in a PIM sparse mode environment.
Field descriptions
Candidacy Whether the router is a candidate BSR
Configured on Interface on which the router is configured
address Address of the router
hashMaskLen Hash mask length
priority Priority of the router
period Time between bootstrap messages, in seconds
Elected BSR This router or IP address of the elected bootstrap router
next BSM If BSR is this router, time until the next bootstrap message is
sent, in seconds
Chapter 3: Configuring PIM for IPv4 Multicast
Monitoring PIM
113